Finished
Mirror Finish Aluminium Sheet
Polished to a specular reflectance above 85%.
Quote within 24 working hours · Certificate type stated on the quote
0.2 – 3.0 mm · 1050 · 1060 · 1070 · 1085 · 1100 · 500
Specification
Mirror Finish Aluminium Sheet — Full Spec Range
These are the ranges we can quote against today. Anything outside them is a mill enquiry, not a stock call — we will say which in the first reply.
| Thickness | 0.2 – 3.0 mm |
|---|---|
| Width | 600 – 1,300 mm |
| Length | Up to 4,000 mm |
| Alloy grades | 1050 · 1060 · 1070 · 1085 · 1100 · 5005 |
| Tempers | H14 · H16 · H18 · H24 |
| Standards | ASTM B209 · EN 485 · GB/T 3880 |
| Surface finish | Mirror (85–95% reflectance) · Brushed · PVC protected |
| Typical applications | Reflector · Lighting · Decorative trim · Solar reflector · Nameplate |
What the mill checks
Four Numbers That Decide Whether This Ships
1Gauge at nine points
Thickness is measured across the full width, not at one spot. A coil that is on gauge at the edge and 0.04 mm light at the centre will still pass a lazy check.
2Mechanical properties per heat
Tensile, yield and elongation pulled from the actual heat, recorded on the EN 10204 3.1 certificate. Not a 2.2 statement of compliance.
3Surface under raking light
Roller marks, oil stain, scratch and edge burr are checked before packing. Coated product is checked for film build and colour delta.
4Packing for the voyage
Kraft plus PE film, steel-strapped pallet, edge protector, desiccant. Photos of the strapping and seal number sent before sailing.
Where it is used
Common End Uses for Mirror Finish Aluminium Sheet
Cookware & Deep Drawing
Deep drawing is a ductility test. Purity and O-temper control decide whether the blank draws or tears.…
Electronics & Heat Management
Heat sinks are an extrusion geometry problem: fin height, fin pitch and flatness tolerance. 6063-T5 holds fine fins that 6061 cann…
Also compare
Related Categories
Aluminium Sheet & Plate
Rolled flat product from 0.2 mm foil stock to 200 mm plate.
0.2 – 200 mm · 600 – 2,200 mm
Aluminium Coil
Continuously cast or hot-rolled coil for roll forming and stamping.
0.2 – 8.0 mm · 600 – 2,200 mm
Aluminium Strip
Slit coil with controlled edge burr and camber.
0.1 – 3.0 mm · 10 – 1,600 mm
Quote on Mirror Finish Aluminium Sheet
Send grade, temper, thickness and quantity. You get price, lead time, MOQ and certificate type in one reply.