Flat Rolled
Aluminium Tread / Checker Plate
Raised-pattern slip-resistant plate: five-bar, three-bar, diamond.
Quote within 24 working hours · Certificate type stated on the quote
1.0 – 8.0 mm · 1050 · 1060 · 3003 · 5052 · 5754 · 606
Specification
Aluminium Tread / Checker Plate — Full Spec Range
These are the ranges we can quote against today. Anything outside them is a mill enquiry, not a stock call — we will say which in the first reply.
| Thickness | 1.0 – 8.0 mm |
|---|---|
| Width | 600 – 2,000 mm |
| Length | Up to 6,000 mm |
| Alloy grades | 1050 · 1060 · 3003 · 5052 · 5754 · 6061 |
| Tempers | H14 · H22 · H24 · H114 · T6 |
| Standards | ASTM B209 · EN 1386 · GB/T 3618 |
| Surface finish | Mill finish · Bright · Anodised |
| Typical applications | Vehicle floor · Dock plate · Stair tread · Ramp · Cold-room floor |
What the mill checks
Four Numbers That Decide Whether This Ships
1Gauge at nine points
Thickness is measured across the full width, not at one spot. A coil that is on gauge at the edge and 0.04 mm light at the centre will still pass a lazy check.
2Mechanical properties per heat
Tensile, yield and elongation pulled from the actual heat, recorded on the EN 10204 3.1 certificate. Not a 2.2 statement of compliance.
3Surface under raking light
Roller marks, oil stain, scratch and edge burr are checked before packing. Coated product is checked for film build and colour delta.
4Packing for the voyage
Kraft plus PE film, steel-strapped pallet, edge protector, desiccant. Photos of the strapping and seal number sent before sailing.
Where it is used
Common End Uses for Aluminium Tread / Checker Plate
Marine & Shipbuilding
Mg-alloyed plate resists seawater and welds without losing strength. This is the series classification societies expect to see on …
Transport & Automotive
Weight reduction per body panel is the entire business case. Formability and weldability decide the grade.…
Building & Curtain Wall
Facade work is a coating problem first and a metal problem second. PVDF film thickness and anodising class are what the specifier …
Also compare
Related Categories
Aluminium Sheet & Plate
Rolled flat product from 0.2 mm foil stock to 200 mm plate.
0.2 – 200 mm · 600 – 2,200 mm
Aluminium Coil
Continuously cast or hot-rolled coil for roll forming and stamping.
0.2 – 8.0 mm · 600 – 2,200 mm
Aluminium Strip
Slit coil with controlled edge burr and camber.
0.1 – 3.0 mm · 10 – 1,600 mm
Quote on Aluminium Tread / Checker Plate
Send grade, temper, thickness and quantity. You get price, lead time, MOQ and certificate type in one reply.